Jump to content
DC Message Boards
Luke_Wilbur

Whirlpool Duet Front Load Dryer Control Locked

Recommended Posts

Luke_Wilbur    5

I pressed the "End of Cycle Signal" button for approximately for five seconds and nothing happenned.

I then unplugged for 10 seconds and replugged the dryer, then I pressed the "End of Cycle Signal" button for approximately for five seconds and still nothing happenned.

 

Anyone have any ideas?

Share this post


Link to post
Share on other sites
Guest Connie   
Guest Connie

Make sure you are pushing the correct button. It is the button that sets if you want a signal at the end of the cycle. Your choices are louder, softer, and off. Push OFF and hold for 3 seconds and your problem should be solved. Most people try the pause, cancel button. That button will not work.

 

That locked signal starts if you happen to back into your dryer. I have done that twice. The END OF CYCLE OFF button has worked both times.

Share this post


Link to post
Share on other sites
Guest Jeronimo   
Guest Jeronimo

If you have this model, PM so I will give instructions since had similar situation so maybe can help...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×